Knight Rider LEDstrip

Hey there, thanks for visiting teslalightshare.io. This site is a one-person operation, fueled by a passion for what I do. Ads play a crucial role in keeping this place alive and kicking. If you enjoy using this site please consider disabling your ad blocker. It's a small gesture that helps a lot. Thanks for stopping by and for your support! If you have any feedback or requests for the site, feel free to reach out to me on X @teslalightshare

I can't get this to work. my car recognises the file and says it's going to start the light show. the windws come down, back one goes up and... nothing. what's going on here? any ideas?

Knight Riderscanner light with sound

Installation: - Unit is pre-taped with 3M double sided tape for easy mounting to any flat surface- Easy 3 wire installation- Simply connect the black wire to any ground wire, the Red wire to your exiting brake or turn wire and the blue wire to an existing running light power source - Works with any 12VDC system, no load equalizer or resistors required

This light bar contains 12 or 21 high power dual intensity LEDs. In running light mode the LEDs sequence from side to side in a "Knight Rider" pattern. When the brake is applied the LED will flash for approximately 5-6 seconds then go to a solid on state until the brake is released. Both modes, running and brake, have been designed to create the maximum visibility. The unit comes pre-taped with 3M double sided tape for easy mounting to any flat surface. Simply connect the black wire to any ground wire, the Red wire to your existing brake light wire, and the blue wire to an existing running light power source. Works with any 12VDC system, no load equalizer or resistors required. Available in Red and Smoked. From Custom Dynamics.